Aem 30-2011 Water Temp Sensor Kit Uživatelský manuál stáhnout pdf

AEM Performance Electronics

2205 126

Street Unit A, Hawthorne, CA. 90250

Phone: (310) 484-2322 Fax: (310) 484-0152

http://www.aemelectronics.com

Instruction Part Number: 10-2011 Rev B

The model 30-2011 Water Temp Sensor kit is specifically designed for fluid temperature measurements in automotive

systems. The kit contains One GM style temperature sensor, the mating connector, 2 terminals and a weld in aluminum

bung.

Housing Material: Brass with 3/8” NPT Thread (Torque to 25 Ft-Lbs)

Elec. Termination: Integral weatherproof connector, Includes mating connector with 2 terminals.

IMPORTANT!

The terminals are “Pull to Seat” meaning you must feed the wire through the connector housing BEFORE you crimp on

the terminals. The wire is then pulled back into the housing and the terminal locks in place. The terminal cannot be

inserted or removed from the rear (wire side entry) of the housing

Wiring to your EMS: Polarity does not matter. Take one wire and tap it to sensor ground at the ECU connector and take

the other wire and hook it up directly to the CLT (Coolant temp) sensor input on the EMS. Please reference your EMS

instructions for pin out details and locations.

Instruction Manual

P/N 30-2011 Water Tem

Sensor

1 2

AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com

Calibration Calibration Temp © Temp (F) Resistance (Ohms) 100 212 180 70 158 500 40 104 1K5 20 68 3K7 0 32 9K8 -20 -4 29K -40 -40 100K

Žádné komentáře

Aem 30-2011 Water Temp Sensor Kit Uživatelský manuál