Aem 30-2067 X-WiFi K-Type Closed Tip Thermocouple Kit Uživatelský manuál stáhnout pdf

INSTALLATION

1. Disconnect the negative battery cable.

2. Using the supplied Stainless Steel 1/8”NPT compression mount, mount the EGT

thermocouple as shown in Figure 2. Common locations for mounting the EGT

thermocouple are 1-2 inches from the exhaust port, 2-3 inches before the turbine

inlet, or in the header collector.

3. Connect the EGT thermocouple to the extension harness as shown in Figure 3.

4. Connect the 3-pin connector on the thermocouple extension harness to either the

EGT 1 location or EGT 2 location as shown above in Figure 1.

When using both thermocouples for comparison (bank 1 EGT and bank 2 EGT for

example), make sure to mount both thermocouples in a similar fashion (distance from

port, tip depth, tube diameter, etc) so the readings are not influenced by installation

differences.

AEM Performance Electronics

2205 126

Street Unit A, Hawthorne, CA. 90250

Phone: (310) 484-2322 Fax: (310) 484-0152

http://www.aemelectronics.com

Instruction Part Number: 10-2320 Rev 01

 2009 AEM Performance Electronics

AEM X-WIFI EGT Connection Guide

Figure 1. Wiring Schematic

1 2

Strany 1

INSTALLATION 1. Disconnect the negative battery cable. 2. Using the supplied Stainless Steel 1/8”NPT compression mount, mo

Page 2 Connecting the Thermocouple Slide the supplied heat shrink onto the sensor cable. Connect the RED wire from the thermocouple to the RED w

Žádné komentáře

Aem 30-2067 X-WiFi K-Type Closed Tip Thermocouple Kit Uživatelský manuál