Aem 30-2067 X-WiFi Wideband UEGO & EGT Controller Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro auto Aem 30-2067 X-WiFi Wideband UEGO & EGT Controller. AEM 30-2067 X-WiFi Wideband UEGO & EGT Controller User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 14
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
AEM Performance Electronics
2205 126
th
Street Unit A, Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
http://www.aemelectronics.com
Instruction Part Number: 10-2320 Rev 01
2009 AEM Performance Electronics
Part Number 30-2320
AEM X-WIFI UEGO/EGT Module
Figure 1. Wiring Schematic
AEM X-WIFI Parts
1 x 30-2320 X-WIFI Module
1 x 30-2001 UEGO Sensor
1 x 35-8535 Install Kit (UEGO Bung and 6 Butt Connectors)
1 x 10-2320 Installation Instructions
1 x 35-3416 8-Pin Power Harness
1 x 35-3400 6-Pin UEGO Sensor Harness
1 x 35-3009 USB Cable
4 x Zip Tie
Zobrazit stránku 0
1 2 3 4 5 6 ... 13 14

Shrnutí obsahu

Strany 1 - AEM X-WIFI UEGO/EGT Module

AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com

Strany 2 - INSTALLATION

Page 10 WIFI AEM X-WIFI is preconfigured for adhoc communications with standard WIFI settings that are suitable for most appli

Strany 3 - >10°

Page 11 To view the advanced configuration screen, open the hyper terminal communication, but do not connect. Plug the USB cable into the pc/lapto

Strany 4

Page 12 Displaying Data with a PC/Laptop Real time AFR and EGT data can also be viewed via a pc/laptop with USB connection. See figure 11. Download

Strany 5

Page 13 Specifications X-WIFI Supply Current (nominal, peak) 1.5A, 3A peak Differential Analog Outputs 3 Measuring Range: UEGO 8.5:1 to 18:1 AF

Strany 6

Page 14 12 MONTH LIMITED WARRANTY Advanced Engine Management Inc. warrants to the consumer that all AEM High Performance products will be free from d

Strany 7

Page 2 INSTALLATION 1. Disconnect the negative battery cable. 2. Find a suitable, in cab, mounting location and secure the X-WIFI module using the

Strany 8

Page 3 Displaying Data with WIFI Enabled Electronic Devices Real time AFR and EGT data from the X-WIFI can be viewed on WIFI enabled electronic devic

Strany 9

Page 4 Status Lights The AEM X-WIFI has two status lights, see Figure 4. The warm up status light on the left flashes during sensor warm up. Once

Strany 10 - Page 10

Page 5 VOLTS LAMBDA AFR GAS AFR METHANOL AFR E85 AFR ETHANOL 0.50 0.58 8.5 3.7 5.6 5.2 0.71 0.61 9.0 3.9 5.9 5.5 0.92 0.65 9.5 4.1 6.3 5.8 1.13 0.68

Strany 11 - Page 11

Page 6 AEM EMS P/N Lambda #1 Pin Lambda #2 Pin Sensor GND Pin 30-1000/1001/1002/1040/1042 D14 D16 D21 30-1010/1012/1050/1052 C16 A23 C18 30-1020/106

Strany 12 - Page 12

Page 7 Connect the WHITE Analog Output + wire to the Aux Gauge input and the BROWN Analog Output – wire to the sensor ground.

Strany 13 - Page 13

Page 8 EGT Measurement Mounting Location Individual Cylinder EGT 1-2 inches from exhaust port Turbine Inlet Temperature 2-3 inches from turbine inlet

Strany 14

Page 9 The analog EGT outputs from the AEM X-WIFI are linear dc voltage signals that vary from 0.5 Vdc at 0 Degrees Fahrenheit (-18 Degrees Celsius)

Komentáře k této Příručce

Žádné komentáře