Aem 30-3020M Water Methanol Failsafe Device Uživatelský manuál

AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com Ins

Page 10 4. Review and adjust the high and low flow limit lines as needed to contour the lines around the baseline flow curve by clicking and dragging

Page 11 DATA LOGGER The Water/Methanol Failsafe has an internal logger that can store approximately 2.5 minutes of injection data. The logger mainta

Page 12 Plot One Parameter Description Flow Measured flow rate in cc/min Lower Flow Limit Lower flow limit value as related to Injection Percentage

Page 13 OUTPUT CONFIGURATION The Water/Methanol Failsafe has two outputs that are triggered when an alarm condition exists; one +12 volt (high side)

Page 14 NC/NO Relay The following are examples of how a NC/NO relay (Bosch PN 0-332-019-203 or similar) can be configured for use with the Water/Met

Page 15 Warning Light The Water/Methanol Failsafe can also be used to directly activate a warning light (Autometer PN 3239 or similar). Connect the

Page 16 Status Lights The Water/Methanol Failsafe gauge has two status lights (see below) that indicate when an alarm has been triggered. The left s

Page 17 Connector Pinouts The pinouts for the 3-pin sensor harness, 4 pin I/O harness, 8-pin power harness, and 5 pin USB harn

Page 18 12 Month Limited Warranty Advanced Engine Management, Inc. warrants to the consumer that all AEM High Performance products will be free from

Page 2 INSTALLATION DIAGRAM OVERVIEW Water/methanol injection is used to lower air charge temps and reduce detonation which allows for aggressive tu

Page 3 The Water/Methanol Failsafe also has an auxiliary input that can be used to trigger an alarm condition. Users with the AEM Water/Methanol Inje

Page 4 Water/Methanol Failsafe Configuration Tab This is the section where the flow monitoring and alarm output functionality of the Water/Methanol F

Page 5 Alarm Configuration Option Description Aux Input Status Shows the status of the auxiliary alarm input; on or off Alarm Delay Period of

Page 6 Gauge Configuration Tab This is the section where the gauge backlighting is configured. Live Gauge View Backlighting Color Option Desc

Page 7 The Water/Methanol Failsafe PC software has a live gauge display. Injection Percentage is shown on the left from 0-100% and flow, in cc/min,

Page 8 WATER/METHANOL FAILSAFE CONFIGURATION The following is a basic guideline strategy for configuring the Water/Methanol Failsafe for the first ti

Page 9 3. With a baseline flow curve now established, click on Auto Set Limits and the software will produce its best suggested high and low flow lim