Aem 30-3301 V2 Water Methanol Injection Kit HD Control Uživatelský manuál

ADVANCED ENGINE MANAGEMENT INC. 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com

Page 10 seconds, and then remain full for another 3 seconds before stopping. Repeat the “TEST” button procedure until you are sure the system is fre

Page 11 Nozzle Mounting Select the location where the nozzle will be installed. Nozzle should be mounted such that it is higher than the tank. Noz

Page 12 System Errors The controller will continuously check for errors; when an error is detected it will be reported to the user by a flashing seq

Page 13 Troubleshooting Diagram

Page 14 Controller Settings The AEM Water Methanol Injection Controller is a progressive type controller. This means that fluid will be injected in

Page 15 Fuse The controller has an externally accessible fuse. The controller itself will turn on and function, but the pump will not run without t

Page 16 Boost-Safe Output (optional) The progressive controller includes a Boost-Safe output (grounded when active) that activates whenever the syst

Page 17 Important Safety Notice Regarding Methanol AEM strongly recommends that users never exceed a 50% methanol concentration when using any AEM

Page 18 Optional System Upgrades Water/Methanol Injection FAILSAFE Device AEM P/N 30-3020/30-3020M Actively monitors the entire flow curve independ

Page 19 AEM Electronics warranty Advanced Engine Management Inc. warrants to the consumer that all AEM High Performance products will be free from

Page 2 Contents Introduction ...

Page 3 Introduction Congratulations on your purchase of the AEM Water/Methanol Injection Kit. This document will help guide you through the setup a

Page 4 Two dial pump speed control Parts List: Quantity Description Part # 20 ft High Pressure ¼” Nylon Hose 35-4500-20 1* 1 Gallon Tank With Integ

Page 5 Installation Diagram *Viewed from wire side of Connector NOTE: THIS KIT INCLUDES NEW STYLE INJECTOR NOZZLES THAT HAVE INTERNAL CHECK VAL

Page 6 Installation Checklist The following list of steps is an overview of the installation process. A complete and more detailed list of each ste

Page 7 Pump and Tank Install Find a suitable location to mount the tank and pump. The tank should be mounted such that it is below the injection po

Page 8 Take note of the direction of flow, indicated by the arrows on the pump body, when mounting the pump. Use four #8 sheet metal screws alo

Page 9 Progressive Controller Installation Pin # Description Wire** Color Connection 1 Pump Ground 16 AWG Orange Connect to ground (black) wire of p