Aem 30-3303 V2 Water Methanol Nozzle and Controller Ki Uživatelský manuál

ADVANCED ENGINE MANAGEMENT INC. 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com

Page 10 System Errors The controller will continuously check for errors; when an error is detected it will be reported to the user by a flashing seq

Page 11 Troubleshooting Diagram

Page 12 Controller Settings The AEM Water Methanol Injection Controller is a progressive type controller. This means that fluid will be injected in

Page 13 Fuse The controller has an externally accessible fuse. The controller itself will turn on and function, but the pump will not run without t

Page 14 Boost-Safe Output (optional) The progressive controller includes a Boost-Safe output (grounded when active) that activates whenever the syst

Page 15 Important Safety Notice Regarding Methanol AEM strongly recommends that users never exceed a 50% methanol concentration when using any AEM

Page 16 Optional System Upgrades Water/Methanol Injection FAILSAFE Device AEM P/N 30-3020/30-3020M Actively monitors the entire flow curve independ

Page 17 AEM Electronics warranty Advanced Engine Management Inc. warrants to the consumer that all AEM High Performance products will be free from

Page 2 Contents Introduction ...

Page 3 Introduction Congratulations on your purchase of the AEM Water/Methanol Injection Kit. This document will help guide you through the setup a

Page 4 Installation Diagram *Viewed from wire side of Connector NOTE: THIS KIT INCLUDES NEW STYLE INJECTOR NOZZLES THAT HAVE INTERNAL CHECK VAL

Page 5 Installation Checklist The following list of steps is an overview of the installation process. A complete and more detailed list of each ste

Page 6 Pump Find a suitable location to mount the pump. The tank and pump must be mounted in the same area. Pump may be mounted on exterior of veh

Page 7 Progressive Controller Installation Pin # Description Wire** Color Connection 1 Pump Ground 16 AWG Orange Connect to ground (black) wire of p

Page 8 seconds, and then remain full for another 3 seconds before stopping. Repeat the “TEST” button procedure until you are sure the system is free

Page 9 Nozzle Mounting Select the location where the nozzle will be installed. Nozzle should be mounted such that it is higher than the tank. Nozz