Aem 30-3352 V2 Water Methanol Nozzle and Controller Ki Uživatelský manuál

ADVANCED ENGINE MANAGEMENT INC. 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com

Page 10 External MAP 0-5V Installation Operation: The 0 – 5 Volt external MAP mode is designed for vehicles running high boost, beyond that of the I

Page 11 Injector Duty Installation Operation: The Injector Duty mode is designed for vehicles where water methanol injection rate is desired to be h

Page 12 0-5V MAF Installation Operation: The 0 – 5 Volt MAF mode is designed for vehicles where MAF is used and the output of their MAF sensor is 0-

Page 13 Frequency MAF Installation Operation: The Frequency MAF mode is designed for vehicles where MAF is used and the output of their MAF sensor i

Page 14 Pump/Tank Flush After all wires are hooked up, add water to the tank and with the hose pointed into a container, press and hold the “TEST” p

Page 15 Nozzle Mounting Select the location where the nozzle will be installed. Nozzle should be mounted such that it is higher than the tank. Noz

Page 16 System Errors The controller will continuously check for errors; when an error is detected it will be reported to the user by a flashing se

Page 17 Troubleshooting Diagram

Page 18 Controller Settings The AEM Water Methanol Injection Controller is a progressive type controller. This means that fluid will be injected in

Page 19 Fuse The controller has an externally accessible fuse. The controller itself will turn on and function, but the pump will not run without t

Page 2 Contents Introduction ...

Page 20 Boost-Safe Output (optional) The progressive controller includes a Boost-Safe output (grounded when active) that activates whenever the syst

Page 21 Important Safety Notice Regarding Methanol AEM strongly recommends that users never exceed a 50% methanol concentration when using any AEM

Page 22 Optional System Upgrades Water/Methanol Injection FAILSAFE Device AEM P/N 30-3020/30-3020M Actively monitors the entire flow curve independ

Page 23 AEM Electronics warranty Advanced Engine Management Inc. warrants to the consumer that all AEM High Performance products will be free from

Page 3 Introduction Congratulations on your purchase of the AEM Water/Methanol Injection Kit. This document will help guide you through the setup a

Page 4 Installation Diagram NOTE: THIS KIT INCLUDES NEW STYLE INJECTOR NOZZLES THAT HAVE INTERNAL CHECK VALVES. AN EXTERNAL CHECK IS NO LONGER

Page 5 Installation Checklist The following list of steps is an overview of the installation process. A complete and more detailed list of each ste

Page 6 Pump Install Find a suitable location to mount the pump. The tank and pump must be mounted in the same area. Pump may be mounted on exterio

Page 7 an externally accessible fuse, no additional fuses are required. Use the supplied zip-ties to mount the controller.

Page 8 Progressive Controller Installation Pin # Description Wire** Color Connection 1 Pump Ground 16 AWG Orange Connect to ground (black) wire of p

Page 9 External MAP, Injector Duty, MAF overview The connection of the External MAP/MAF pin will depend on the desired mode of operation. Please fol