Aem 30-4100 Digital Wideband UEGO Gauge Uživatelský manuál

ADVANCED ENGINE MANAGEMENT INC. 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aempower.com Instr

Page 10 Specifications Gauge Supply Current (nominal): 1.3 amps 0-5V Analog Outputs: 1 Measuring Range: 0.751 to 1.143 Lambda Harness & Connec

Page 2 Congratulations! The 52mm (2-1/16”) AEM Universal Exhaust Gas Oxygen (UEGO) Gauge features a digital readout and sweeping 24 color-coded ligh

Page 3 vehicles. Its unique design makes precision AFR measurements possible over the entire operating range. UEGO sensors use a “current pump” to de

Page 4 Gauge-Type UEGO Controller Installation RED <Power> Connect to a switched 10-18 volt power source utilizing a 10A fuse. BLACK <Gro

Page 5 Below is a list of AFR values that should be entered into the 02 Sensor #1(#2) Cal Table if inputting the analog signal to an AEM EMS. These

Page 6 Connecting to Stand alone ECU’s When connecting to a third party EFI system, the AEM UEGO gauge’s WHITE Analog Output wire shall be connected

Page 7 Data logging with HyperTerminal UEGO Sensor If attempting to route the UEGO Sensor through a tight space, AEM recommends temporally removing t

Page 8 time or plan on running leaded race fuel then you must mount the sensor at least 36 inches or more downstream of the exhaust port as all of the

Page 9 P4P3P2P1P0ROTARY SWITCH Calibration screw position settings The calibration will not be changed until the rotary switch reaches the middle of