Aem 30-5135M Analog Oil Metric Pressure Gauge Uživatelský manuál stáhnout pdf

AEM Performance Electronics

2205 126

Street Unit A, Hawthorne, CA. 90250

Phone: (310) 484-2322 Fax: (310) 484-0152

http://www.aemelectronics.com

Instruction Part Number: 10-5133 Rev 02

 2010 AEM Performance Electronics

Part Number 30-5133

Analog Style 100 PSI Oil/Fuel/Air Pressure Gauge

NOTE: Faceplate Configuration Instructions Included on Separate Sheet

Figure 1. Wiring Schematic

AEM Oil/Fuel Pressure Gauge Parts

1 x 35-5133 Pressure Gauge Assembly

1 x 30-2131-100 Pressure Sensor

1 x 35-4302 Install Kit (6 Butt Connectors)

1 x 10-5133 Installation Instructions

1 x 35-3411 8-Pin Power Harness

1 x 35-3412 3-Pin Sensor Harness

1 x 35-8529S Silver Bezel

1 x 35-8540W Oil Pressure Faceplate, White

1 x 35-8543B Fuel Pressure Faceplate, Black

1 x 35-8543W Fuel Pressure Faceplate, White

1 x 35-8549W Air Pressure Faceplate, White

1 x 35-8549B Air Pressure Faceplate, Black

1 x Faceplate Configuration Instructions

1 x Paper Clip Needle Removal Tool

1 2 3 4 5 6

AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com

Page 2 INSTALLATION 1. Disconnect the negative battery cable. 2. Secure the gauge in a 2 1/16th” (52MM) mounting hole with the supplied bracket. 3.

Page 3 Changing the Bezel and Faceplate The gauge kit comes with the black bezel and black faceplate installed. However, the kit also comes with a s

Page 4 Status Lights The AEM Pressure gauge has two status lights, see Figure 4. The status light on the left will flash if an out of range low v

Page 5 Analog Output The analog output from the AEM 100 PSI Pressure gauge is a linear dc voltage signal that varies from 0.5 Vdc at 0 psig (0 Bar) t

Page 6 Specifications Gauge Supply Current 0.1 A Differential Analog Outputs 1 Measuring Range 0 PSI – 100 PSI 0 Bar to 6.9 Bar Operating Voltage (

Žádné komentáře

Aem 30-5135M Analog Oil Metric Pressure Gauge Uživatelský manuál