Aem 30-8760 CAS Trigger Disc Uživatelský manuál

 2010 ADVANCED ENGINE MANAGEMENT INC. 2205 126th Street Unit A Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aempow

 2010 ADVANCED ENGINE MANAGEMENT INC. 2205 126th Street Unit A Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aempow

**Cam / Crank Angle Sensor: AEM trigger disc MUST be used Discrepancies have been observed in the OEM cam/crank angle trigger discs betw

Figure 1: Location of CAS Figure 2: Location of CAS

Figure 3: Removal of vacuum line from blow-off valve Figure 4: Removal of intake tube

Figure 5: Removal of intake tube Figure 6: CAS cover

Figure 7: Removal of CAS cover Figure 8: Cover removed

Figure 9: Removal of original CAS disc Figure 10: Original CAS screw removed

Figure 11: Washer removed Figure 12: Original CAS disc removed

Figure 13: Installation of AEM CAS disc Figure 14: AEM CAS disc installed

© 2010 ADVANCED ENGINE MANAGEMENT INC. 2205 126th Street Unit A Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aempowe

Page 2 of 9 **Cam / Crank Angle Sensor: AEM trigger disc MUST be used Discrepancies have been observed in the OEM cam/crank angle trigger

2**Cam / Crank Angle Sensor: AEM trigger disc MUST be used Discrepancies have been observed in the OEM cam/crank angle trigger discs between model

3Instructions with photos on the following pages: Remove the distributor cap with the #1 Phillips screwdriver as shown in figure 1 by removing the t

4Remove the internal cover over the CAS disc as shown in figure 3. Figure 3: Removal of internal cover over CAS disc Remove the screw holding the C

5When collar and screw are removed, the assembly will look like figure 5. Figure 5: Original CAS screw and collar removed Install the AEM CAS disc

6Reinstall the screw that holds the CAS disc with some red threadlocker with the #2 Phillips screwdriver as shown in figure 7. Figure 7: Screw and

Page 3 of 9 Instructions with photos on the following pages: Remove the MAF sensor assembly as shown in figure 1. The arrow points to a mount that m

Page 4 of 9 Remove the plastic cover as shown in figure 3. Figure 3: Plastic wire cover removed Remove the back part of the outer plastic

Page 5 of 9 Remove the distributor rotor with carefully with the pry bar as shown in figure 5, taking note of how the rotor was oriented on the sha

Page 6 of 9 Remove the internal CAS disc cover shown in figure 7 with a #2 Phillips screwdriver. Figure 7: Removal of internal CAS disc cover Remov

Page 7 of 9 Figure 9 shows the original CAS disc with the collar that holds it in place removed. The original disc can be removed now. For future use

Page 8 of 9 The collar and screw can be reinstalled as shown in figure 11. Figure 11: Trigger disc and collar reinstalled The internal CAS disc co

Page 9 of 9 The internal plastic cover is reinstalled as shown in figure 13. Figure 13: Internal plastic cover reinstalled Reassemble the rest of